Fundamentally speaking, this is a normal phenomenon, because the marking command and marking content of the software have been sent to the board. If you close the software, it is equivalent to waiting for the board to execute the last command, and it will be out of control. It may grow light the follow up,… Continue reading I turned off the marking software, but the laser is still marking.
Multiple marking boards are required to control multiple lasers and galvos (up to 8), and to connect to the same computer. The boards need to enable the multi-head function and dial different serial numbers on the DIP switch. Connect each board to the computer, open the multi-head software to set the marking area of each scanner(galvo) , and… Continue reading How to use a computer to control multiple lasers for marking?
First determine whether the calibration of the galvo is accurate, and then accurately calculate the fly speed coefficient of the encoder. Check the Reverse Encoder Signals to make the software display speed positive, and statically adjust the Laser On TC to make the content marking complete.
a. Check whether the equipment is effectively grounded. b. Check the interference source on the equipment site and do shielding treatment. c. Check the wiring method of the equipment, and the weak current and strong current of the equipment are required to be wired separately, and isolation protection should be done. d. Check whether there… Continue reading Laser marking board card is lost during the marking process?
When opening the vector drawing, select “Show preview” and check “Put to center“. If you find that the filling is not complete, you can select “Auto connect curve“, click Apply to center.
The F3 parameter Password is found in the “Plug” folder – “markcfg” to find “PSW=***”, *** is the F3 parameter password. The user management password is in the “Param” folder – after opening “UserParam.ini”, you can see “m_strPsw=***”, *** is the user management password.
The language packs currently installed on your computer are displayed here. The languages included in the software are Simplified Chinese, Traditional Chinese, English, Japanese, and Korean. You can change the language used by the EzCad2 software here. It should be noted that the change made this time will not take effect until the next time… Continue reading How to change the software language?
Confirm whether the laser power supply is normal. If it is normal, you need to make a short connector for the laser marking control board. CON2 10 and 11 are shorted, 14 and 16 are shorted, then open the Ezcad to start mark to see if there is an error prompt, if there is no?prompt,… Continue reading What should I do if there is a temperature alarm?
When marking variable text, because each character occupies a different space, the marked texts may be longer or shorter. What should I do if I want to mark the text with the same length? Check “Advanced“, click “Enable fixed text width“, and set. Note: This function is only for variable text, fixed text cannot be used. The… Continue reading How to make the variable text marked with the same length?